i2ES 3002 is a hand operated tool to cut SIL / DIL leads on substrates after soldering operation has taken place.

Length is adjusted by means of a grub screw. A presser provides accurate lead cutting without any mechanical stress being applied to solder joint. Provided that strip is kept adherent to back reference, it is possible to cut multiple circuits.

Cutting range: minimum is 4 mm - maximum is almost up to lead frame tie-bar.

Note: zero reference point is defined on bottom Tie-Bar.

Circuit dimensions: maximum strip length is 6" (152.4 mm).

DIL circuits: from 20 mm to 130 mm substrate width.